This standard is issued under the fixed designation D ; the number 1 This test method is under the jurisdiction of ASTM Committee D on Soil and Rock. GeoTesting Express is a provider of Soil Testing Services – ASTM D, Standard Test Method for Compressive Strength of Molded Soil-Cement Cylinders. ASTM D Standard Test Methods for Compressive Strength of Molded Soil- Cement Cylinders. MasterLoader Load Frame.

Author: Mahn Shaktimuro
Country: Botswana
Language: English (Spanish)
Genre: Personal Growth
Published (Last): 9 November 2007
Pages: 327
PDF File Size: 11.9 Mb
ePub File Size: 9.79 Mb
ISBN: 836-1-59403-792-8
Downloads: 72230
Price: Free* [*Free Regsitration Required]
Uploader: Mooguzshura

Historical Version s – view previous versions of standard. It is considered that Method A gives a relative measure of strength rather than a rigorous determination of compressive strength. Because of the lesser height to diameter ratio 1.

Active Risk Management

As a result, it has been customary to evaluate or specify compressive strength values as determined by Method A. A factor for converting compressive strength values based on height to diameter ratio is aastm in Section 8.

The quality of the result produced by this standard is dependent on the competence of the personnel performing it and the suitability of the equipment and facilities used. Users of this standard are cautioned that compliance with Practice D does not in itself ensure reliable results.


ASTM D – 00 Standard Test Method for Compressive Strength of Molded Soil-Cement Cylinders

Reliable results depend on many factors; Practice D provides a means of evaluating some of those factors. This test method is applicable to those materials that pass the 4. The values given in d633 are mathematical conversions to SI units, and are provided for information only and are not considered standard.

Sieve sizes are identified by the standard designations in Specification E The alternative sieve size designation given in parentheses is for information only and does not represent a different standard sieve size. In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs. Therefore, the standard unit for mass in this standard is either kilogram kg or gram gor both.

This implicitly combines two separate systems of units; that is, the d11633 system and the gravitational system. It is scientifically undesirable to combine the use of two separate sets of inch-pound units within a single standard. In addition, they are representative of the significant digits that generally should be retained.


ASTM D – Standard Test Method for Compressive Strength of Molded Soil-Cement Cylinders

The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits astk reported data to be commensurate with these considerations.

It is beyond the scope of these test methods to consider significant digits used in analysis methods for engineering data.

It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Link to Active This link will always route to the current Active version of the standard.